Clutch Switch: Service and Repair

Removal Procedure

Caution: Refer to Battery Disconnect Caution in Service Precautions.

1. Disconnect the negative battery cable.
2. Remove the connector from the CPP switch.






3. Remove the CPP switch (2) from the clutch and from the brake pedal bracket by turning the CPP switch counterclockwise.
4. Remove the CPP switch lock nut (1) from the CPP switch.
5. Inspect the CPP switch for damage. Replace the switch as necessary.

Installation Procedure

^ Tools Required
- J39200 Digital Multimeter

Notice: Refer to Fastener Notice in Service Precautions.






1. Install the CPP switch lock nut to the CPP switch.
Tighten the CPP switch lock nut (1) to 13 Nm (115 inch lbs.).
2. Use J39200 in order to adjust the CPP switch.
3. Install the Clutch Pedal Position (CPP) switch (2) into the clutch and into the brake pedal bracket by turning the CPP switch clockwise.






4. Depress the clutch pedal (2) to the floor (3). Return the clutch pedal 15 - 30 mm (0.6 - 1.2 inch) from the floor.






5. Adjust the probes of J39200 in contact with both leads of the CPP switch electrical connector (2).
6. Adjust the CPP switch by threading the switch into the clutch and into the brake pedal bracket until continuity is achieved.
7. Install the CPP switch lock nut.
Tighten the CPP switch lock nut to 13 Nm (115 inch lbs.)
8. Connect the connector to the CPP switch.
9. Connect the negative battery cable.