Operation CHARM: Car repair manuals for everyone.

Spark Plug: Service and Repair

REMOVAL PROCEDURE

NOTE: This engine is equipped with an aluminum cylinder head. Allow the engine to cool before removing spark plugs. Removing the spark plugs from an engine at operating temperature may damage the spark plug threads in the cylinder head. Also be sure to clean any dirt or debris from around spark plug holes prior to removing spark plugs.

IMPORTANT: Note the correct routing of the wires prior to removal in order to maintain the correct engine firing order.




1. Remove the spark plug wires from the spark plugs.
2. Remove the spark plugs from the cylinder head.
3. Inspect the spark plugs for electrode wear, for carbon deposits, and for damage to the insulator. Refer to Spark Plug Visual Diagnosis.

INSTALLATION PROCEDURE

NOTE: Refer to Fastener Notice in Service Precautions.




1. Use one of the following types of spark plugs:
^ AC Type R42XLS
^ Denso Type W20EPR-U11
^ NGK Type BPR6ES-11
2. Set the spark plug gap to 1.0-1.1 mm (0.039-0.043 in).
3. Install the spark plugs to the cylinder head.

Tighten
Tighten the spark plugs to 28 N.m (21 lb in).

4. Correctly route the the spark plug wires, and install the spark plug wires to the spark plugs.