AIR BAG Warning Lamp Does Not Come On

AIR BAG Warning Lamp Does Not Come On (Part 1 of 3):

AIR BAG Warning Lamp Does Not Come On (Part 2 of 3):

AIR BAG Warning Lamp Does Not Come On (Part 3 of 3):

Wiring Diagram:

CIRCUIT DESCRIPTION
When the ignition switch is first turned to the ON position, the IG-COIL Fuse applies battery voltage to the AIR BAG warning lamp that is connected to the AIR BAG INDICATOR, terminal 7. The AIR BAG fuse applies battery voltage to the IGNITION 1 input, terminal 8. The inflatable restraint Sensing and Diagnostic Module (SDM) responds by flashing the AIR BAG warning lamp seven times.

When measurements are requested in this table, use J 39200 Digital Multimeter with the correct terminal adapter from J 35616-A Connector Test Adapter kit. When a check for proper connection is requested, refer to Intermittents and Poor Connections. When a wire, connector or terminal repair is requested, use J 36125-B Terminal Repair Kit and refer to Wiring Repair. Intermittents and Poor Connections

TEST DESCRIPTION
The numbers below refer to the step numbers on the diagnostic table.
2. This test determines if the malfunction is in the inflatable restraint Sensing and Diagnostic Module (SDM) circuitry or in the instrument cluster power feed circuitry.
3. This test determines if voltage is present in the warning lamp circuit.
4. This test isolates the ORN wire to B+ and checks for a short in the ORN wire to B+.
6. This test determines if the malfunction is in the instrument cluster connector.
8. This test determines if the open is due to a malfunctioning bulb.
10. This test isolates an open in the warning lamp circuitry.
13. This test checks it power is available to the instrument cluster power feed circuit.
14. This test checks for a short from the instrument cluster power feed circuit to ground.
15. This test determines whether the short to ground is due to a short in the wiring or internal to the instrument cluster.
19. This test determines it the malfunction is in the instrument cluster connector.
21. This test determines if the malfunction is due to an open power feed circuit from the IG-COIL METER Fuse.