Wheel Speed Sensor Replacement (Rear)

Removal Procedure





1. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
2. Remove the Rear wheel. Refer to Tire and Wheel Removal and Installation.
3. Disconnect the rear wheel speed sensor electrical connector (2).
4. Remove the retaining bolt (1).
5. Remove the rear wheel speed sensor (3) from the rear suspension knuckle.

Installation Procedure





1. Install the rear wheel speed sensor (3) to the rear suspension knuckle.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the retaining bolt (1).
- Tighten the retaining bolt (1) to 10 Nm (86 inch lbs.).
3. Connect the rear wheel speed sensor electrical connector (2).
4. Install the Rear wheel. Refer to Tire and Wheel Removal and Installation.
5. Lower the vehicle.
6. Perform A Diagnostic System Check - ABS. Diagnostic System Check