20. Parking Pawl and Manual Shaft Linkage Installation

1. Inspect the manual shift shaft seal (7088) at the transaxle case and replace the seal if necessary.
2. Install the manual shift shaft (7086) into the transaxle case. Be careful not to damage the manual shift shaft seal (7088).
3. Install the shift shaft upper washer and the manual shift lever (7090) to the manual shift shaft (7086).
4. Install the manual lever locknuts (7091).
- Tighten both manual shift lever locknuts to 33 Nm (24 ft. lbs.). Completely tighten the lower locknut before securing the upper locknut.





5. Install the manual detent spring assembly (7092).
- Tighten the manual detent spring assembly retaining bolt (7096) to 12 Nm (106 inch lbs.).
- Tighten the manual detent spring assembly nut (7094) to 12 Nm (106 inch lbs.).

6. Inspect the manual shift shaft for smooth rotation.





7. Install the restrictor pin (7084) and the snap ring (7083) onto the parking lock pawl sleeve (7082).
8. Install the parking lock pawl sleeve (7082) into the transaxle case.
9. Move the manual shift lever to any position other than Park.





10. Install the parking lock pawl (7079), the lock pawl spring (7080) and the lock pawl shaft (7081) onto the transaxle case.
11. Inspect the parking lock pawl for smooth operation by moving the manual shift lever in and out of Park.