Wheel Speed Sensor Jumper Harness Replacement (Front)

Removal Procedure





1. Disconnect the wheel speed sensor jumper to harness connector, (located near the strut tower inside the engine compartment).
2. Raise and support the vehicle on a suitable hoist. Refer to Vehicle Lifting.
3. Disconnect the wheel speed sensor electrical connector (1).
4. Remove the three bolts retaining the harness to the vehicle.
5. Remove the harness from the vehicle.

Installation Procedure

Notice: Refer to Fastener Notice in Service Precautions.





1. Install the jumper harness to the vehicle; secure with three bolts.
- Tighten the jumper harness retaining bolts to 8 Nm (71 inch lbs.).
2. Connect the wheel speed sensor electrical connector (1).
3. Lower the vehicle.
4. Connect the wheel speed sensor jumper to harness connector.
5. Perform A Diagnostic System Check - ABS. Diagnostic System Check