Engine Support Fixture

Installation Procedure

^ Tools Required
- J 28467-A Engine Support Fixture
- J 28467-89 Engine Support Fixture Adapter

1. Remove the hood. Refer to Hood Replacement in Body and Frame.

Caution: Refer to Battery Disconnect Caution in Service Precautions.

2. Disconnect the negative battery cable.





3. Install the thread support nuts (J 28467-89) onto the strut attaching studs.
4. Install the strut tower support assemblies (J 28467-5A).
5. Install the T-bolts (J 28467-53) with 5/16 inch washers through the strut tower support assemblies (J 28467-5A) into the thread support nuts and hand tighten.
6. Install the two cross bracket assemblies (J 28467-1A) over the strut tower tube (J 28467-3).
7. Install the strut tower tube (J 28467-3) into the strut tower support assemblies (J 28467-5A).
8. Install the 1/2 inch x 2.5 inch quick release pin (J 28467-10) through the strut tower support assemblies (J 28467-5A) and the strut tower tube (J 28467-3) on one side only.
9. Hand tighten the passenger side cross bracket assembly (J 28467-1A) wing nuts.
10. Install the engine support adapter kit (J 42451).
11. Hand tighten the lift hook wing nuts (J 28467-34) securely to remove all slack from the engine support fixture assembly.