Overhaul Procedure Steps

NOTE: This article lists the sequential steps necessary to overhaul the transmission.
- For the specific step listed below, refer to that step under "Repair Instructions".
- For the complete list of procedures, refer to "Repair Instructions".




Overhaul Procedure:



[ ] Torque Converter and Transaxle Case Disassemble
[ ] Speedometer Driven Gear and VSS Disassemble
[ ] Transaxle Range Switch Disassemble
[ ] Fluid Pan, Filter Screen and Fluid Pipes Removal
[ ] Valve Body, Accumulators, & Solenoid Wiring Harness Removal

[ ] Intermediate Servo Overhaul
[ ] Fluid Pump Assemble Removal
[ ] Transaxle Case Housing Removal
[ ] Inter Band and Forward/Direct Clutch Disassemble
[ ] Reaction Gear Sets and One Way Clutch Disassemble

[ ] Rear Case Cover Removal
[ ] Differential Assemble Removal
[ ] Reduction Driven Gear, Countershaft, Output Shaft Disassemble
[ ] 1st Reverse Brake Assembly Disassemble
[ ] Parking Pawl and Manual Shift Linkage Removal

[ ] Parts Cleaning and Inspection
[ ] Countershaft Bearings Overhaul
[ ] Output Shaft Bearing Overhaul
[ ] Differential Assemble Overhaul
[ ] 1st Reverse Brake Assembly Assemble

[ ] Parking Pawl and Manual Shaft Linkage Installation
[ ] Countershaft Assemble
[ ] Output Shaft Assemble
[ ] Differential Assembly Installation
[ ] One-Way Clutch Overhaul

[ ] Reaction Gear Sets Assemble
[ ] Intermediate Band and Servo Assemble
[ ] Direct Clutch Overhaul
[ ] Forward Clutch Overhaul
[ ] Transaxle Case Housing Installation

[ ] Fluid Pump Assembly Overhaul
[ ] Forward Clutch and 2nd Brake Accumulators Assemble
[ ] Valve Body Removal
[ ] Upper Valve Body Overhaul
[ ] Lower Valve Body Overhaul

[ ] Valve Body Assemble
[ ] Solenoid Wiring Harness Installation
[ ] Fluid Pan, Filter Screen, Fluid Pipes Installation
[ ] Speedometer Driven Gear and VSS Assemble
[ ] Transaxle Range Switch Assemble
[ ] Torque Converter and Transaxle Case Assemble