33. Upper Valve Body Overhaul

- Tools Required
- J 34673 Flat Gage Bar





1. Remove four check balls (7105) from the upper valve body (7101).





2. Remove the following parts from the upper valve body:
- The number 3 valve body key (7108)
- The pressure regulator valve sleeve (7109)
- The primary regulator valve plunger (7110)
- The plate washer (7111)
- The primary regulator valve spring (7112)
- The primary regulator valve (7113)





3. Remove the following parts from the upper valve body:
- The neutral drain nozzle (7106)
- The manual valve (7107)
- The throttle valve cam bolt (7114), the lock washer (7115), and the washer (7116)
- The throttle cam (7117), the throttle valve cam bushing (7118), and the throttle valve cam spring (7119)
- The downshift plug (7120)
- The number 2 throttle valve spring (7121)
- The throttle valve (7122)
- The E-clip retainer (7123) from the throttle valve
- The number 1 throttle valve spring (7124)

4. Clean all parts thoroughly with solvent. Air dry.





5. Inspect the upper valve body for the following conditions:
- Valve bores for distortion or damage
- Fluid passages for blockage
- Surface warp. Place a J 34673 across the upper valve body mating surface. Rotate the tool every 30 degrees checking for surface warp. If upper valve body surface warp exists, replace the upper valve body.

6. Inspect all valves, springs and attaching parts for unusual wear or damage. Replace as necessary.

INSTALLATION PROCEDURE
- Tools Required
- J 36850 TRANSJEL(r) Transmission Assembly Lubricant

IMPORTANT: Apply a thin coat of J 36850 to all parts prior to assembly.





1. Install the following parts into the upper valve body:
- The number 1 throttle valve spring (7124)
- The E-clip retainer (7123) to the throttle valve
- The throttle valve (7122)
- The number 2 throttle valve spring (7121)
- The downshift plug (7120)
- The throttle cam (7117), the throttle valve cam bushing (7118), and the throttle valve cam spring (7119). Secure the throttle valve cam with:
- The throttle cam washer (7116)
- The throttle cam lock washer (7115)
- The throttle cam bolt (7114)
- Tighten the throttle valve cam bolt to 4 Nm (35 inch lbs.).
- The manual valve (7107)
- The neutral drain nozzle (7106)





2. Install the following parts into the upper valve body:
- The primary regulator valve (7113)
- The primary regulator valve spring (7112)
- The plate washer (7111)
- The primary regulator valve plunger (7110)
- The pressure regulator valve sleeve (7109)
- The number 3 valve body key (7108)





3. Install four check balls (7105) into the upper valve body.
4. Inspect all valves for smooth operation.