Operation CHARM: Car repair manuals for everyone.

B3267

Diagnostic Chart:




Schematic:




CIRCUIT DESCRIPTION
The rear compartment lid release relay is controlled by the body control module (BCM). The BCM supplies a ground signal to the rear compartment lid release relay when the keyfob button is pressed through circuit 1344. If circuit 1344 is grounded or open, DTC B3267 is set.

CONDITIONS FOR RUNNING THE DTC
The supply voltage to the BCM is within the normal operating range (aproximately 9-16 volts).

CONDITIONS FOR SETTING THE DTC
Any of the following conditions will set this DTC:
^ The rear compartment lid release relay control circuit is open for 500 milliseconds.
^ The rear compartment lid release relay control circuit is shorted to ground for 500 milliseconds.

ACTION TAKEN WHEN THE DTC SETS
The BCM turns off the rear compartment lid release relay control output for the remainder of the current ignition cycle.

CONDITIONS FOR CLEARING THE DTC
^ A current DTC B3267 will clear when the malfunction is longer present and the ignition switch is cycled.
^ All BCM history codes clear after 100 ignition cycles (from OFF to ON) with no current codes active during the 100 ignition cycles.

DIAGNOSTIC AIDS
^ If circuit 1344 is shorted to ground, the rear compartment lid will not latch closed.
^ If the DTC is a history DTC, the problem may be intermittent. Perform the tests while wiggling the wiring and connectors. This will often cause the malfunction to appear.

TEST DESCRIPTION
The number(s) below refer to the step number(s) on the diagnostic table.
2. Listen for an audible click when the rear compartment lid release relay operates. Command both the ON and OFF states. Repeat the commands as necessary.
3. Tests for voltage at the coil side of the rear compartment lid release relay. The TRUNK REL/RFA/RADIO AMP fuse supplies power to the coil side of the rear compartment lid release relay.
4. Verifies that the body control module is providing ground to the rear compartment lid release relay.
5. Tests if ground is constantly being applied to the rear compartment lid release relay.