P0462

Refer to Engine Controls Schematics Fuel System.

Diagnostic Chart:

CIRCUIT DESCRIPTION
The Powertrain Control Module (PCM) uses the fuel level input in order to calculate the expected vapor pressures within the fuel system. These vapor pressures vary as the fuel level changes. The vapor pressure is critical in determining if the evaporative emissions system is operating properly. The PCM also uses the fuel level in order to determine if the fuel level is too high or too low to be able to accurately detect EVAP system malfunction.

CONDITIONS FOR RUNNING THE DTC
- The ignition is ON.
- The system voltage is between 10.0-18.0 volts.

CONDITIONS FOR SETTING THE DTC
The Fuel Level Sensor should be less than 3 percent for more than 10 seconds.

ACTION TAKEN WHEN THE DTC SETS
^ The PCM will not illuminate the Malfunction Indicator Lamp (MIL).
^ The PCM will store conditions which were present when the DTC set as Failure Records data only. This information will not be stored as Freeze Frame data.

CONDITIONS FOR CLEARING THE MIL/DTC
^ A History DTC will clear after 40 consecutive warm-up cycles have occurred without a malfunction.
^ The DTC can be cleared by using a scan tool.

IMPORTANT: Remove any debris from the connector surfaces before servicing a component. Inspect the connector gaskets when diagnosing or replacing a component. Ensure that the gaskets are installed correctly. The gaskets prevent contaminate intrusion.

^ Faulty terminal connections
Inspect the harness connectors for backed-out terminals, improper mating, broken locks, improperly formed or damaged terminals, and faulty terminal-to-wire connections. Use a corresponding mating terminal in order to test for proper tension. Refer to Testing for Intermittent and Poor Connections and Connector Repairs in Diagrams for diagnosis and repair.
^ Damaged harness.
Inspect the wiring harness for damage. If the harness inspection does not reveal a problem, observe the display on the scan tool while moving the connectors and the wiring harnesses that are related to the sensor. A change in the scan tool display may indicate the location of the fault. Refer to Circuit Testing and Wiring Repairs in Diagrams for diagnosis and repair. Inspect the PCM and the engine grounds for clean and secure connections.

If the DTC is determined to be intermittent, reviewing the Failure Records can be useful in determining when the DTC was last set.

TEST DESCRIPTION
The numbers below refer to the step numbers on the diagnostic table.
1. The Powertrain On Board Diagnostic (OBD) System Check prompts the technician to complete some basic checks and to store the Freeze Frame and Failure Records data on the scan tool if applicable. This creates an electronic copy of the data taken when the malfunction occurred. The information is then stored in the scan tool for later reference.
3. This step tests for the proper operation of the fuel level circuit in the low voltage range.
4. This step tests for the proper operation of the fuel level circuit in the high voltage range. If the fuse in the jumper opens when you preform this test, the signal circuit is shorted to ground.