Procedures

REMOVAL PROCEDURE




1. Remove the door trim panel from the door.
2. Remove the window rear run channel.
3. Remove the inside door handle.
4. Remove the outside door handle.
5. Remove the door lock actuator retaining bolts.
6. Remove the actuator from the door.

INSTALLATION PROCEDURE




1. Install the door lock actuator to the door.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the actuator bolts.

Tighten
Tighten the bolts to 7 N.m (60 lb in).

3. Install the outside door handle.
4. Install the inside door handle.
5. Install the window rear run channel.
6. Install the door trim panel.