Tap-Down Function

In order to tap down, complete the following steps:
1. Ensure that the cruise is engaged and operating.
2. Quickly press the Set/Coast button to the depressed position.
3. Quickly release the button (or tap the button). Do not hold the button in the depressed position or the system will revert to the coast mode.

The tap-down function allows you to decrease the cruise speed by 0.62 km/h (1 mph) increments (one tap equals a 1 mph decrease). The system may tap-down until it reaches the low speed lockout of 40 km/h (25 mph). The cruise will be inoperative

Resume/Accel Switch
The Resume/Accel switch is located on the right side of the steering wheel.

The Resume/Accel switch has the following two positions:
^ Normal
^ Depressed

Resume Position

IMPORTANT: The Resume will not function unless the Set button has been previously set on the current ignition cycle.

The Resume switch returns the cruise control operation to the last speed setting by momentarily depressing the switch after braking. If you hold the switch in the RESUME/ACCEL position for more than one second, the system reverts to the Accel mode.

Accel Position
In order to accelerate the vehicle, perform the following steps:
1. Verify that the cruise control On/Off switch is in the ON position.
2. Ensure that the vehicle is above the low speed lockout which is approximately 40 km/h (25 mph).
3. Press the Resume switch.
4. Hold the Resume switch until the vehicle reaches the desired speed.
5. Release the Resume switch.

The speed the vehicle has accelerated to becomes the new cruise speed when you release the Resume/Accel switch.