Procedures

REMOVAL PROCEDURE




1. Turn OFF the ignition.
2. Disconnect the Mass Air Flow (MAF) sensor electrical connector.
3. Disconnect the IAT sensor electrical connector.
4. Disconnect the breather tube from the air intake duct.
5. Loosen the 2 air intake duct clamps and remove the air intake duct.
6. Remove the air cleaner assembly retainer screws.
7. Remove the air cleaner assembly from the vehicle.




8. Separate the Mass Air Flow (MAF) sensor from the air filter element cover.
9. Remove the Air filter element retaining screws and remove the cover.
10. Remove the air filter element. Inspect the air filter element and replace if necessary.

INSTALLATION PROCEDURE




1. Install the air filter element in the air cleaner assembly.
2. Position the air filter cover on the air cleaner assembly.

NOTE: Refer to Fastener Notice in Service Precautions.

3. Install the air filter retainer screws.

Tighten
Tighten the screws to 5-7 N.m (35-45 lb in).

4. Install the MAF sensor to the air filter cover.




5. Place the air cleaner assembly in the vehicle.

NOTE: Refer to Fastener Notice in Service Precautions.

6. Install the air cleaner assembly retainer screws.

Tighten
Tighten the air cleaner retainer screws to 5-7 N.m (35-45 lb in).

7. Install the air intake duct.
8. Tighten the 2 air intake duct clamps.
9. Connect the breather tube to the air intake duct.
10. Connect the IAT sensor electrical connector.
11. Connect the Mass Air Flow (MAF) sensor electrical connector.