Crankshaft Position (CKP) Sensor Replacement (7X)

REMOVAL PROCEDURE
1. Turn OFF the ignition.
2. Crank the steering wheel fully to the left.

CAUTION: Refer to Vehicle Lifting Caution in Service Precautions.

3. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
4. Disconnect the sensor electrical connector.
5. Remove the attaching bolt/screw.
6. Remove the sensor from the engine.
7. If the sensor is not being replaced, inspect for wear, cracks, or leakage.

INSTALLATION PROCEDURE
1. Lubricate the O-ring with clean engine oil before installation and replace if damaged.
2. Install the sensor to the block.

NOTE: Refer to Fastener Notice in Service Precautions.

3. Reinstall the sensor attaching bolt.

Tighten
Tighten the bolt to 8 N.m (71 lb in).

4. Connect the sensor electrical connector.
5. Lower the vehicle.