Tilt Spring

Disassembly Procedure

Caution: Refer to Tilt Spring Caution in Service Precautions.

1. Use the tilt lever to move the tilt column into the UP position.





2. Pry the tilt spring (1) upward until a bulge occurs and most of the spring tension is removed.
3. Secure the tilt spring (1) with locking pliers.
4. Continue prying the tilt spring (1) until the tilt spring disengages from the post on the steering column support assembly, the steering column housing, and the bearing assembly.





5. Remove the tilt spring guide (1) from the tilt spring (2).

Assembly Procedure





1. Install the tilt spring guide to the tilt spring.





2. Install the tilt spring (1) to the post on the steering column support assembly.
3. Secure the tilt spring (1) with locking pliers by performing the following steps:
3.1. While the end of the tilt spring is on the post, pull the center of the tilt spring (1) while pushing the tilt spring guide end to the post on the bearing and housing assembly.
3.2. With both ends installed on the post, push the tilt spring into position.