Glove Box Lock Cylinder - Replacement Update
File In Section: 08 - Body and AccessoriesBulletin No.: 00-08-49-010
Date: October, 2000
SERVICE MANUAL UPDATE
Subject:
Addition of Instrument Panel (I/P) Compartment Door Lock Cylinder Replacement Information
Models:
1999-2000 Oldsmobile Alero
1999-2000 Pontiac Grand Am
This bulletin is being issued to add the Instrument Panel Compartment Door Lock Cylinder Replacement Procedure to the Instrument Panel, Gauges and Console sub-section of the Service Manual.
This information has been added to SI2000. If you are using the paper version of this Service Manual, please mark a reference to this bulletin in the Service Manual.
Instrument Panel Compartment Door Lock Cylinder Replacement
Removal Procedure
Important:
Servicing the I/P compartment door lock cylinder will result in a small hole left in the inside top edge of the compartment door. The customer should be advised of this before servicing the lock cylinder.
1. Open the I/P compartment door in order to expose the small dimple located above the lock cylinder.
2. Use a 3 mm (1/8 in) drill bit in order to drill out the dimple.
3. Insert the key into the lock cylinder.
4. Insert a very small screw driver or pick into the drilled hole and apply pressure to the lock cylinder release tab.
5. Rotate the key in the lock cylinder using the key to pull the lock cylinder from the I/P compartment door.
Installation Procedure
1. Install the lock cylinder into the I/P compartment door until fully seated into place.
2. Inspect the operation of the lock cylinder before closing the I/P compartment door.
Disclaimer