Shift Control Replacement

Removal Procedure

Caution: Refer to Battery Disconnect Caution in Service Precautions.





1. Remove the negative battery cable.
2. Remove the cable (4) at the transmission (2) shift control assembly (3).
3. Remove the cable at the transaxle cable bracket.
4. Remove the center console. Refer to Console Replacement in Instrument Panel, Gauges and Warning Indicators.
5. Remove the cable at the shift control assembly.
6. Remove the cable grommet at the cowl.
7. Remove the cable from the vehicle.

Installation Procedure





1. Install the cable through the cowl and carpet.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the cable grommet and the bolts in the cowl.
Tighten
Tighten the grommet bolts to 2 Nm (17 inch lbs.).
3. Install the cable (4) at the shift control assembly (3).
4. Install the center control. Refer to Cupholder Replacement - Front Floor Console in Instrument Panel, Gauges and Warning Indicators.





5. Install the cable at the transmission cable brackets (1).
6. Install the cable at the transmission selector lever (2).
7. Install the negative battery cable.
8. Adjust the cable.
9. Place the shift lever in NEUTRAL. You can find NEUTRAL by rotating the selector shaft clockwise from PARK through REVERSE to NEUTRAL.
10. Place the shift control assembly in NEUTRAL.





11. Pull the cable locking clip fully upward.
12. Push the on the cable adjuster in order to adjust cable in the cable mounting bracket.