Torque Converter: Service and Repair

Removal Procedure

Caution: Refer to Battery Disconnect Caution in Service Precautions.





1. Disconnect the negative battery cable.
2. Remove the transmission assembly from the vehicle. Refer to Transmission Replacement.
3. Remove the torque converter assembly from the transmission.





4. Remove the torque converter O-ring seal from the end of the turbine shaft. Use a screwdriver.

Installation Procedure





1. Install a new torque converter O-ring seal on the end of the turbine shaft.
2. Install the torque converter onto the transmission.
3. Install the transmission into the vehicle. Refer to Transmission Replacement.
4. Connect the negative battery cable.
5. Adjust the transmission oil level. Refer to Transmission Fluid Checking Procedure in Diagnostic Information & Procedures.