Input Shaft Assemble

^ Tools Required
- J 24433 Press Tube

Important: The machined surface faces the needle thrust bearing.





1. Install the 5th gear using J 24433 and a hydraulic press.





2. Install the thrust bearing (2).
3. Install the two caged needle bearings (1).





4. Install the 3rd gear (4).
5. Install the 3rd gear blocking ring (3).
6. Install the thrust bearing (2).
7. Install the thrust washer (1).





Important:
^ The machined surface of the synchronizer faces the thrust washer.
^ Make sure to align the slots in the synchronizer with the gear blocking ring tabs.

8. Install the 3rd/4th synchronizer using the J 24433 and a hydraulic press.





Important: Make sure the oil hole on the bearing collar is 900 from the oil hole in the shaft.

9. Install the bearing collar using an appropriate tool and a hydraulic press.





10. Install the 4th gear blocking ring (5).
11. Install the caged needle bearing (4).
12. Install the 4th gear (3).

Important: The pocketed side of the thrust bearing faces the thrust washer.

13. Install the thrust bearing (2).
14. Install the thrust washer (1).