Operation CHARM: Car repair manuals for everyone.

P0656

Diagnostic Chart (Part 1 Of 2):




Diagnostic Chart (Part 2 Of 2):




Engine Controls Schematics: I/P, Generator and Driver Information Display:






CIRCUIT DESCRIPTION
Output driver modules (ODMs) are used by the PCM to turn on many of the current-driven devices that are needed to control various engine and transaxle functions. ODMs have the capability of diagnosing each output circuit individually. DTC P0656 set indicates an improper voltage level on the output circuit that controls the fuel gauge.

CONDITIONS FOR RUNNING THE DTC
The ignition is ON.

CONDITIONS FOR SETTING THE DTC
^ An improper voltage level has been detected on the output circuit which controls the fuel gauge.
^ The above conditions are present for at least 30 seconds.

ACTION TAKEN WHEN THE DTC SETS
^ The PCM will not illuminate the Malfunction Indicator Lamp (MIL).
^ The PCM will store conditions which were present when the DTC set as Failure Records data only. This information will not be stored as Freeze Frame data.

CONDITIONS FOR CLEARING THE MIL/DTC
^ A History DTC will clear after 40 consecutive warm-up cycles have occurred without a malfunction.
^ The DTC can be cleared by using a scan tool.

DIAGNOSTIC AIDS
Inspect for the following conditions:

IMPORTANT: Remove any debris from the connector surfaces before servicing a component. Inspect the connector gaskets when diagnosing or replacing a component. Ensure that the gaskets are installed correctly. The gaskets prevent contaminate intrusion.

^ Poor terminal connection.
Inspect the harness connectors for backed out terminals, improper mating, broken locks, improperly formed or damaged terminals, and faulty terminal to wire connection. Use a corresponding mating terminal to test for proper tension. Refer to Diagrams for diagnosis and repair.
^ Damaged harness.
Inspect the wiring harness for damage. If the harness inspection does not reveal a problem, observe the display on the scan tool while moving connectors and wiring harnesses related to the sensor. A change in the scan tool display may indicate the location of the fault. Refer to Diagrams for diagnosis and repair.
^ Inspect the PCM and the engine grounds for clean and secure connections.

If the DTC is determined to be intermittent, reviewing the Failure Records can be useful in determining when the DTC was last set.

TEST DESCRIPTION
The numbers below refer to the step numbers on the diagnostic table:
3. Normally, ignition feed voltage should be present on the output control circuit with the PCM disconnected and the ignition turned on.
4. Tests for a shorted component or a short to B+ on the output control circuit. Either condition would result in a measured current of over 1.5 amps. Also inspects for a component that is going open while being operated, resulting in a measured current of 0 amps.
5. Tests for a malfunctioning instrument cluster.
16. This vehicle is equipped with a PCM which utilizes an Electrically Erasable Programmable Read Only Memory (EEPROM). When the PCM is being replaced, the new PCM must be programmed.