Adding the Customers Code

Perform the following steps in order to add the customer's code:
1. Turn the ignition to the ACC or RUN position.
2. Turn the radio OFF.

IMPORTANT: If SEC is displayed the theft deterrent feature is already activated. Remove the old code before entering the new code.

3. Press and hold the pushbuttons 1 and 4 for approximately 6 seconds until the display changes to _______
4. Press the HR button.
5. Set the first 2 digits (0-19) of the code with the HR button.
6. Set the next 2 digits (0-99) with the MIN button.
7. Press the AM-FM button in order to enter the code.
8. Repeat steps 3-5 when REP then 00 are displayed. This will confirm the following:
- The customer's code
- Activates the theft deterrent feature
- After step 5, will display SEC, which shows that the theft deterrent feature has been activated.

IMPORTANT: If--- is displayed after pressing the AM-FM button, the customer's code has not been entered.

9. Anytime the ignition is removed and the THEFTLOCK(R) is activated, the THEFTLOCK(R) light will flash once every 2 seconds. When the battery power is cycled and the ignition is ON, the display will show LOC. The radio will then need to be unlocked by either the customer's code or by the factory backup code.