Console Replacement - Front Floor

REMOVAL PROCEDURE




1. Disconnect the battery ground negative cable.
2. Remove the rear storage compartment from the front floor console.
3. Remove the front floor console trim plate.
4. Remove the shift control lever and indicator bezel.




5. Remove the rear bolts from the front of the floor console in the rear storage compartment.
6. Remove the center bolts front floor console at the transaxle shift lever mounting bracket.
7. Remove the front bolts from the front floor console.




8. Disconnect the electrical connectors.
9. Pull the front floor console rearward in order to release the front floor console from the guide pins in the Instrument Panel.
10. Remove the front floor console from the vehicle.

INSTALLATION PROCEDURE




1. Position the front floor console to the vehicle.
2. Connect the electrical connectors.




3. Align the front floor console to the guide pins in the Instrument Panel.
4. Push the front floor console forward into the Instrument Panel until the front floor console guide pins are fully seated.

NOTE: Refer to Fastener Notice in Service Precautions.

5. Install the front floor console center bolts at the transaxle shift lever mounting bracket.

Tighten
Tighten the front floor console center bolts to 5 N.m (44 lb in).

6. Install the front floor console rear bolts in the rear storage compartment.

Tighten
Tighten the front floor console rear bolts to 5 N.m (44 lb in).

7. Install the front bolts to the front floor console.

Tighten
Tighten the front floor console bolts to 2 N.m (18 lb in).




8. Install the shift control lever and indicator bezel.
9. Install the front floor console trim plate.
10. Install the rear storage compartment to the front floor console.
11. Connect the battery ground negative cable.