10 Minute Re-Learn Procedure

Use this procedure after replacing:
- The ignition lock cylinder.
- The theft deterrent module
- The Powertrain Control Module (PCM) if necessary, see Important above.

TOOLS REQUIRED
- Tech 2
- Techline Terminal with current Service Programing System (SPS) software
1. Connect the Tech 2 scan tool to the vehicle's Data Link Connector (DLC).
2. Select Request Information under Service Programing.
3. Disconnect the Tech 2 from the vehicle and connect it to a Techline Terminal.
4. On the Techline Terminal, select Theft Module Re-Learn under Service Programming.
5. Disconnect the Tech 2 from the Techline Terminal and re-connect it to the vehicle's DLC.
6. Turn the ignition switch to RUN, with the engine OFF, using a master Passkey III key (black).
7. Select VTD Re-Learn under Service Programming.
8. At this point the Tech 2 must remain connected to the DLC for the duration of the 10 minute re-learn period.
9. Observe the SECURITY indicator, after approximately 10 minutes the SECURITY indicator will turn off. The vehicle is now ready to re-learn the key information and/or passwords on the next ignition switch cycle from OFF/LOCK to RUN.
10. Turn the ignition switch to OFF/LOCK and wait 5 seconds.
11. Start the vehicle (the scan tool has now learned the key and password information).
12. With the scan tool, clear any DTCs