Exhaust Seal Replacement (Catalytic Converter)

Removal Procedure





1. Raise and suitably support the vehicle. Refer to Vehicle Lifting.

Notice: Refer to Catalytic Converter Movement Notice in Service Precautions.

Important: Exercise caution handling the pipe that contains an oxygen sensor. Do not cut the wire. For removal or repositioning disconnect the connector.

2. Support the exhaust pipe and the three-way catalytic converter pipe.

Important: Suitably support the exhaust system where hangers are removed.

3. In order to remove the three-way catalytic converter seal disconnect any hangers necessary to reposition the exhaust system.
4. Remove the exhaust system bolts from the three-way catalytic converter pipe flange.
5. Reposition the exhaust system.
6. Remove the three-way catalytic converter seal.

Installation Procedure





1. Install the three-way catalytic converter seal.
2. Install the exhaust system.
3. Connect any hangers.

Notice: Refer to Fastener Notice in Service Precautions.

4. Install the exhaust system bolts through the three-way catalytic converter pipe flange.
^ Tighten the exhaust system bolts to 45 Nm (33 ft. lbs.)
5. Remove the exhaust system support.
6. Inspect the system for leaks.
7. Lower the vehicle.