Accelerator Controls Cable Bracket Replacement

REMOVAL PROCEDURE




1. Disconnect the accelerator cable cross slug from throttle body slot.
2. Depress the tangs and remove the accelerator cable from accelerator cable bracket.




3. If applicable disconnect the cruse control cable from the throttle lever and cable bracket.




4. Remove the nuts and bolts holding the accelerator cable bracket to the throttle body.
5. Remove the accelerator cable bracket.

INSTALLATION PROCEDURE




1. Install the accelerator cable bracket to throttle body.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Reinstall the nuts and bolts.

Tighten
^ Tighten the nuts to 10 N.m (89 lb in).
^ Tighten the bolts to 13 N.m (115 lb in).




3. Connect the accelerator cable into accelerator cable bracket.
4. Connect the accelerator cable cross slug into throttle body slots.




5. If applicable connect the cruse control cable to the throttle lever and cable bracket.