Camshaft Position Sensor: Service and Repair

NOTE: The Camshaft Position Sensor graphic illustrates the original factory installation. Do not route the new sensor pigtail as shown. Follow the Installation procedure below. Handle carefully in order to avoid damage to the sensor and pigtail. Route away from electronic components in order to avoid Electromagnetic Interference (EMI).

Locations View:

REMOVAL PROCEDURE
1. Disconnect the negative battery cable.
2. Remove the serpentine drive belt.
3. Remove the power steering pump assembly.
4. Remove the cam sensor electrical connector.
5. Remove the attaching bolt.
6. Remove the sensor.
7. Inspect the sensor for wear, cracks or leakage if the sensor is not being replaced.

INSTALLATION PROCEDURE
1. Lubricate the O-ring with clean engine oil and replace if damaged.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the Camshaft Position Sensor.

Tighten
Tighten the retaining bolt to 10 N.m (8 lb ft).

3. Connect the cam sensor electrical connector.
4. Reinstall the power steering pump.
5. Install the serpentine drive belt.
6. Reconnect the negative battery cable.