P1571

Diagnostic Chart (Part 1 Of 2):

Diagnostic Chart (Part 2 Of 2):

Engine Controls Schematics: Automatic Transaxle, EBCM, Performance Shift Switch And Stop Lamp Switch:

CIRCUIT DESCRIPTION
The traction control system uses the antilock brake system in conjunction with the PCM fuel and ignition controls to limit drive wheel slippage during acceleration. The PCM controlled portion of the traction control system reduces engine torque by any or all of the following methods:
^ Retarding spark timing
^ Altering air/fuel ratio
^ altering boost PWM
^ Shutting OFF up to three injectors

To determine the amount of torque reduction required, the PCM monitors the TCS Desired Torque PWM signal from the Electronic Brake and Traction Control Module (EBTCM). The PCM also provides a TCS Delivered Torque PWM informing the Electronic Brake and Traction Control Module (EBTCM) how much torque is being produced by the engine. The Desired Torque display on the scan tool indicates the amount of engine torque requested by the EBTCM. With traction control not active, Desired Torque should vary between 99 percent and 100 percent. The Desired Torque display on the scan tool is not the PWM duty cycle.

CONDITIONS FOR SETTING THE DTC
^ Desired torque signal PWM duty cycle is less than 5 percent or greater than 95 percent.
^ The conditions exists for up to 10 seconds

ACTION TAKEN WHEN THE DTC SETS
^ The PCM will not illuminate the Malfunction Indicator Lamp (MIL).
^ The PCM will store conditions which were present when the DTC set as Failure Records data only. This information will not be stored as Freeze Frame data.

CONDITIONS FOR CLEARING THE MIL/DTC
^ A History DTC will clear after 40 consecutive warm-up cycles have occurred without a malfunction.
^ The DTC can be cleared by using a scan tool.

DIAGNOSTIC AIDS
An intermittent may be caused by a poor connection, rubbed through wire insulation or a broken wire inside the insulation. Inspect for the following conditions:

IMPORTANT: Remove any debris from the connector surfaces before servicing a component. Inspect the connector gaskets when diagnosing or replacing a component. Ensure that the gaskets are installed correctly. The gaskets prevent contaminate intrusion.

^ Poor terminal connection.
Inspect the harness connectors for backed out terminals, improper mating, broken locks, improperly formed or damaged terminals, and faulty terminal to wire connection. Use a corresponding mating terminal to test for proper tension. Refer to Diagrams for diagnosis and repair.
^ Damaged harness.
Inspect the wiring harness for damage. If the harness inspection does not reveal a problem, observe the display on the scan tool while moving connectors and wiring harnesses related to the sensor. A change in the scan tool display may indicate the location of the fault. Refer to Diagrams for diagnosis and repair.
^ Inspect the PCM and the engine grounds for clean and secure connections.

If the DTC is determined to be intermittent, reviewing the Failure Records can be useful in determining when the DTC was last set.