Malfunction Indicator Lamp (MIL) Inoperative

Diagnostic Chart:

Engine Controls Schematics: Power, Ground, MIL and Data Link:

CIRCUIT DESCRIPTION
There should always be a steady MIL with the ignition ON, and with the engine OFF. Ignition feed voltage is supplied directly to the MIL bulb. The Powertrain Control Module (PCM) turns the MIL ON by grounding the MIL driver circuit. No MIL with the ignition ON, with the engine OFF and DTC P1671 set suggests an open in the MIL driver circuit.

MIL OPERATION
The Malfunction Indicator Lamp (MIL) is located on the instrument panel (CHECK ENGINE) or (SERVICE ENGINE SOON). The MIL performs the following functions:
^ It informs the driver that a problem has occurred and that the vehicle should be taken for service as soon as possible.
^ As a bulb test and system test, the MIL will illuminate with the ignition ON and the engine OFF. When the engine is started, the MIL will turn OFF. If the MIL remains ON, the self-diagnostic system has detected a problem. If the problem goes away, the MIL will turn OFF in most cases, but a diagnostic trouble code will remain stored.
^ If the MIL is illuminated, then the engine stalls, the MIL will remain illuminated as long as the ignition is ON.
^ Now, if the MIL is not illuminated and the engine stalls, the MIL will not illuminate until the ignition is cycled OFF, then ON.

Perform the Powertrain On Board Diagnostic (OBD) System Check first, when the following conditions are present:
^ The MIL does not turn ON when the ignition switch is turned to the RUN position
^ The MIL remains ON while the engine is running
^ When you suspect a driveability problem

DIAGNOSTIC AIDS
An intermittent may be caused by a poor connection, rubbed through wire insulation or a broken wire inside the insulation. Inspect for the following items:
^ The PCM harness and connectors for improper mating, broken locks, improperly formed or damaged terminals, poor terminal to wire connection, and damaged harness.
^ If the engine runs OK, test for a faulty bulb, an open in the MIL driver circuit, or an open in the instrument cluster ignition feed.
^ If the engine cranks but will not run, test for an open PCM ignition or battery feed or a poor PCM to engine ground.

NO MALFUNCTION INDICATOR LAMP (MIL)
Numbers below refer to the step numbers on the Diagnostic Table:
2. If the MIL DTC is set, the MIL Control Circuit table will better diagnose the condition.
6. Using a test lamp connected to B+, probe each of the PCM ground terminals to ensure that a good ground is present.