Ignition Control Module: Service and Repair

REMOVAL PROCEDURE
1. Disconnect the negative battery cable.
2. Disconnect the 14-way connector from the Ignition Control Module.
3. Disconnect the spark plug wires from the coil assemblies (note the position that the wires were removed).
4. Remove 6 screws (1) securing the coil assemblies to the Ignition Control Module.
5. Remove the coils (2) from the ignition control module (3).
6. Remove the 2 nuts and washers under the module bracket.
7. Remove the ignition control module.

INSTALLATION PROCEDURE
1. Attach the coils to the Ignition Control Module. Refer to Ignition Coil(s) Replacement.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install 6 ignition coil attaching screws.

Tighten
Tighten the screws to 4-5 N.m (40 lb in).

3. Install the nuts and washers securing the Ignition Control Module assembly to the mounting bracket.

Tighten
Tighten the nuts to 8 N.m (70 lb in).

4. Connect the spark plug wires.
5. Connect the 14-way connector to module.
6. Reconnect the negative battery cable.