Air Cleaner Element Replacement

REMOVAL PROCEDURE
1. Disconnect the IAT sensor electrical connector.
2. Disconnect the MAF sensor electrical connector.
3. Loosen the air intake duct/MAF sensor hose clamps.
4. Remove the air intake duct/MAF sensor assembly.
5. Carefully remove the air inlet hose from the throttle body and air cleaner cover.
6. Remove the 2 housing cover retaining clamps.
7. Remove the air cleaner cover (5) and carefully remove the air filter element (6).
8. Inspect the housing cover (4), seal assembly, and air ducting (2) for damage. If a problem is found, replace as necessary.

INSTALLATION PROCEDURE
1. Carefully install the air filter element (6) into the air cleaner assembly (1).
2. Reinstall the housing cover and reinstall the housing cover retaining screws.
3. Carefully reinstall the air inlet hose to the throttle body and air cleaner cover.
4. Tighten the air inlet hose clamp.
5. Reinstall the air intake duct/MAF sensor assembly.
6. Tighten the air intake duct/MAF sensor hose clamps.
7. Connect the MAF sensor electrical connector.
8. Connect the IAT sensor electrical connector.