Wiper Motor Cover Replacement

REMOVAL PROCEDURE

TOOLS REQUIRED
J 39232 Wiper Transmission Separator




1. Remove the wiper arm assemblies from the vehicle.
2. Remove the air inlet grille panel from the vehicle.
3. Remove the connector from the wiper motor assembly.
4. Remove the wiper transmission assembly from wiper motor crank arm assembly using the J 39232.




5. Remove three screws and the wiper drive system module from the vehicle.




6. Remove three screws and the wiper motor cover from the wiper motor assembly.

INSTALLATION PROCEDURE

TOOLS REQUIRED
J 39529 Wiper Transmission Installer.

NOTE: Refer to Fastener Notice in Service Precautions.




1. Install the wiper motor cover on the wiper motor assembly with three screws.

Tighten
Tighten screws to 2 N.m (18 lb in).




2. Install the wiper drive system module on the vehicle with three screws.

Tighten
Tighten screws to 10 N.m (88 lb in).




3. Install the wiper transmission assembly on the wiper motor crank arm assembly using the J 39529.
4. Install the connector to the wiper motor assembly.
5. Install the air inlet grille panel on the vehicle.
6. Install the wiper arm assemblies on the vehicle.
7. Operate the wipers and check for proper operation.