Coolant Temperature Sensor/Switch (For Computer): Service and Repair

REMOVAL PROCEDURE

NOTE: Use care when handling the coolant sensor. Damage to the coolant sensor will affect the operation of the fuel control system.

1. Turn OFF the ignition switch.
2. Drain the coolant system. Refer to Draining and Filling Cooling System in Cooling System.
3. Disconnect the ECT sensor electrical connector.
4. Carefully remove the ECT sensor.

INSTALLATION PROCEDURE
1. Coat only the threads of the ECT sensor with thread sealer.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the ECT sensor in the engine.

Tighten
Tighten the ECT sensor to 23 N.m (17 lb in).

3. Connect the ECT sensor electrical connector.
4. Refill the engine coolant system. Refer to Draining and Filling Cooling System in Cooling System.