54. Final Drive End Play Check #2

Tools Required
- J 26958 Output Shaft Aligning & Loading Tool
- J 26958-10 Adaptor Plug
- J 25025 Post
- J 8001 Dial Indicator
- J 28585 Snap Ring Remover





1. Rotate the transmission so that the right side axle seal (117) is facing upward.

IMPORTANT: Leave J 26958-10 adaptor in position.

2. Remove J 26958 which was installed in order to perform the Low Roller Clutch Race End Play Check procedure.
3. Install J 25025 and J 8001 with the indicator stem touching J 26958-10.
4. Set the dial indicator so that the pointer is at zero.
5. Insert J 28585 into the case through the governor bore, and gently pry up on the governor drive gear (679).
6. The dial indicator should read 0.12-0.82 mm (0.005-0.032 inch).
7. Record the reading.
8. In order to select the correct final drive thrust washer (680), refer to the Selective Thrust Washer table in End Play Specifications under Transmission Specifications. End Play Specifications