Door Replacement

Door Replacement

Removal Procedure

1. Raise the window to the full UP position.
2. Remove the door trim panel.
3. Remove the water deflector in order to access the wire harness.




4. Disconnect the wire harness from all the components in the door.
5. Remove the rubber conduit from the door.
6. Remove the wire harness from the door through the conduit access hole.
7. Support the door.
8. Mark the position of the door hinge to the hinge pillar.
9. Remove the lower hinge bolt (4) and nut (3) from the hinge pillar.
10. Remove the upper hinge bolt (1) and nut (2) from the hinge pillar.
11. Remove the door from the body.
12. Mark the position of the door hinge to the door.
13. Remove the lower hinge bolts from the door.
14. Remove the upper hinge bolts from the door.

Installation Procedure






Notice: Door hinge parts could cause damage to other door components if not replaced with the same part or equivalent. Do not use replacement parts of lesser quality or substitute design. Specified torque values must be used during assembly in order to ensure proper retention.

1. Attach the upper hinge bolts snugly to the door in order to ensure that the door is movable.
2. Attach the lower hinge bolts snugly to the door in order to ensure that the door is movable.
3. Install the door to the body.
4. Attach the upper hinge bolt (1) and nut (2) snugly in order to ensure that the door is movable.
5. Attach the lower hinge bolt (4) and nut (3) snugly in order to ensure that the door is movable:
6. Carefully close the door.
7. Adjust the door for proper alignment.
8. Slowly open the door.

Notice: Refer to Fastener Notice in Service Precautions.

9. Install the upper hinge bolt (1) and nut (2) to the hinge pillar.

Tighten the bolt (1) and nut (2) to 26 N.m (19 lb ft).

10. Install the lower hinge bolt (4) and nut (3) to the hinge pillar.

Tighten the bolt (4) and nut (3) to 26 N.m (19 lb ft).

11. Install the upper hinge bolts to the door.

Tighten the bolts to 26 N.m (19 lb ft).

12. Install the lower hinge bolts to the door.

Tighten the bolts to 26 N.m (19 lb ft).

13. Inspect the door for proper alignment. Repeat the installation procedure from the beginning if the door is not aligned properly.
14. Install the wire harness through the conduit access hole.
15. Install the rubber conduit to the door.
16. Connect the components to the door wire harness.
17. Install the water deflector.
18. Install the trim panel.