Park/Turn Signal Lamp Replacement

REMOVAL PROCEDURE
1. Remove the splash shield.
2. Remove the socket from the lamp assembly. Twist and pull outward.
3. Pull the bulb outward to remove.
4. Remove the retaining nuts (2) from the lamp assembly.
5. Push the lamp assembly (1) outward from the fascia.

INSTALLATION PROCEDURE
1. Install the lamp assembly (1).

NOTE: Refer to Fastener Notices in Service Precautions.

2. Install the retaining nuts (2).

Tighten
Tighten the retaining nuts to 2 N.m (18 N.m lb in).

3. Install the socket to the lamp assembly.
4. Install the splash shield.