P/S Pressure Hose Replacement

Removal Procedure





1. Remove the power steering pressure hose (2) from the power steering pump (1).
2. Raise the vehicle on a hoist. Refer to Vehicle Lifting.
3. Remove the front exhaust pipe, automatic transmission only. Refer to Intermediate Pipe Replacement in Exhaust System.





4. Remove the power steering pressure hose (1) from the power steering gear (3).
5. Remove the power steering hose retainer (2).
6. Remove the power steering pressure hose (1) from the vehicle.

Installation Procedure

Notice: Refer to Notice - Installing Hoses Without Twists or Bends in Service Precautions.





1. Install the power steering pressure hose (1) to the vehicle
2. Install the power steering hose retainers (2).

Notice: Refer to Fastener Notice in Service Precautions.

3. Install the power steering pressure hose (1) to the power steering gear (3).
- Tighten the fitting to 27 Nm (20 ft. lbs.).
4. Install the front exhaust pipe, if removed. Refer to Intermediate Pipe Replacement in Exhaust System.
5. Lower the vehicle.





6. Install the power steering pressure hose (2) to the power steering pump (1).
- Tighten the fitting to 27 Nm (20 ft. lbs.).
7. Bleed the power steering system. Refer to Bleeding Power Steering System.