Rear

Removal Procedure





1. Raise and support the vehicle on a suitable hoist. Refer to Vehicle Lifting.
2. Disconnect the two rear wheel speed sensor electrical connectors (3) from the rear wheel bearing and speed sensor assemblies (2).
3. Disconnect the rear axle harness electrical connector from the body to ABS and fuel sender connector.
4. Remove the rear axle harness retainers (1).
5. Remove the rear axle harness from the vehicle.

Installation Procedure





1. Install the rear axle harness to the vehicle.
2. Install the rear axle harness retainers (1).
3. Connect the rear axle harness electrical connector to the body to ABS and fuel sender connector.
4. Connect the two rear wheel speed sensor electrical connectors (3) to the rear wheel bearing and speed sensor assemblies (2).
5. Lower the vehicle.
6. Perform the A Diagnostic System Check - ABS.