Crankshaft Position Sensor: Service and Repair

REMOVAL PROCEDURE




1. Remove the air cleaner outlet resonator.
2. Remove the Crankshaft Position (CKP) sensor harness connector at the module.




3. Remove the CKP sensor mounting bolt (2).
4. Remove the CKP sensor from the engine (1).
5. Inspect the CKP sensor O-ring for wear, cracks, or leakage. Replace the unit if necessary.

INSTALLATION PROCEDURE




1. Install the Crankshaft Position (CKP) sensor (1) into the block.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the CKP sensor mounting bolt (2).

Tighten
Tighten the CKP sensor mounting bolts to 8 N.m (71 lb In).




3. Install the CKP sensor harness connector.
4. Lower the vehicle.

INSTALLATION PROCEDURE




1. Install the Crankshaft Position (CKP) sensor (1) into the block.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the CKP sensor mounting bolt (2).

Tighten
Tighten the CKP sensor mounting bolts to 8 N.m (71 lb In).




3. Install the CKP sensor harness connector.
4. Install the air cleaner outlet resonator.
Perform the CKP System Variation Learn Procedure. Refer to CKP System Variation Learn Procedure. Programming and Relearning