Battery Negative Cable Disconnect/Connect Procedure
REMOVAL PROCEDURECAUTION:
^ This vehicle has a Supplemental Inflatable Restraint (SIR) System. Failure to follow the correct procedure could cause air bag deployment, personal injury, or unnecessary SIR system repairs. To help avoid that: (1) Refer to SIR Component Views to determine if you are performing service on or near the SIR components or the SIR wiring. (2) If you are performing service on or near SIR components or the SIR wiring, you must disable the SIR system, refer to Disabling the SIR System.
^ Before servicing any electrical component, the ignition key must be in the OFF or LOCK position and all electrical loads must be OFF, unless instructed otherwise in these procedures. If a tool or equipment could easily come in contact with a live exposed electrical terminal, also disconnect the negative battery cable. Failure to follow these precautions may cause personal injury and/or damage to the vehicle or its components.
1. Record all of the vehicle preset radio stations.
2. Turn OFF all the lamps and the accessories.
3. Make sure the ignition switch is in the OFF position.
4. Disconnect the battery negative cable from the battery.
INSTALLATION PROCEDURE
NOTE: Refer to Fastener Notice in Service Precautions.
IMPORTANT: Clean any existing oxidation from the contact face of the battery terminal and battery cable using a wire brush before installing the battery cable to the battery terminal.
Connect the battery negative cable to the battery.
Tighten
Tighten the battery negative terminal bolt to 16 N.m (12 lb ft).