Operation CHARM: Car repair manuals for everyone.

Vehicle Damage Warnings

CAUTION:
^ This vehicle has a Supplemental Inflatable Restraint (SIR) System. Failure to follow the correct procedure could cause air bag deployment, personal injury, or unnecessary SIR system repairs. To help avoid that: (1) Refer to SIR Component Views to determine if you are performing service on or near the SIR components or the SIR wiring. (2) If you are performing service on or near SIR components or the SIR wiring, you must disable the SIR system, refer to Disabling the SIR System.
^ Before servicing any electrical component, the ignition key must be in the OFF or LOCK position and all electrical loads must be OFF, unless instructed otherwise in these procedures. If a tool or equipment could easily come in contact with a live exposed electrical terminal, also disconnect the negative battery cable. Failure to follow these precautions may cause personal injury and/or damage to the vehicle or its components
.

NOTE: This vehicle has a 12 Volt, negative ground electrical system. Make sure the vehicle or equipment being used to jump start the engine is also 12 Volt, negative ground. Use of any other type of system will damage the vehicle's electrical components. This vehicle has a 12 volt positive, negative ground electrical system. Do not try to jump start a vehicle if you are unsure of the other vehicle's positive voltage or ground position. The booster (charged) battery and the discharged battery should be treated carefully when using jumper cables.

NOTE: Turn OFF the ignition when connecting or disconnecting the battery cables, the battery charger or the jumper cables. Failure to do so may damage the PCM or other electronic components.

CAUTION: Before removing or installing any electrical unit, or when a tool or equipment could easily come in contact with "live" or "hot all the times" exposed electrical terminals, disconnect the negative battery cable to help prevent personal injury and/or damage to the vehicle or components. Unless instructed otherwise, the ignition switch must be in the OFF or LOCK position.