Steering Shaft, Lower Bearing & Jacket - Assemble

Assembly Procedure





1. Install the support mounting bracket (2).
2. Lubricate the new support screws (1) with LOCTITE(R).

Notice: Refer to Fastener Notice in Service Precautions.

3. Install 4 support screws (1).
Tighten the new support screws to 8 Nm (71 inch lbs.).





4. Install the steering shaft assembly (2) into the steering column jacket assembly.

Important: The bearing retainer must be seated correctly on the steering shaft.

5. Install the new bearing retainer (1).
6. Install the adapter and bearing assembly (3).
7. Install the lower bearing seat (4).

Important: When installing, compress the lower bearing spring (5) to the length of 23.5 MM +/- 0.5 MM between the lower bearing seat (4) and the lower spring retainer (6).

8. Install the lower bearing spring (5).
9. Install the new lower spring retainer (6).
10. Install the steering column housing assembly. Refer to Steering Column placket - Assemble - Off Vehicle.