117. TCC Solenoid and Wiring Harness Assemble

1. Inspect the TCC solenoid (353) for damage or for cut wires.
2. Inspect the wiring harness assembly (339) for nicks, cuts, or damaged connectors.





3. Insert the TCC solenoid seal ring (337) onto the TCC solenoid (333).
4. Install the solenoid (333) into the auxiliary valve body.
5. Install the bolt (334).
- Tighten the bolt to 11 Nm (98 inch lbs.).

6. Connect the wire harness clip to the auxiliary control valve body.
7. On some models, connect the harness to the governor oil pressure switch.
8. On some models, connect the wire harness to the second clutch apply oil pressure switch.
9. Attach the wire harness (339) to the electrical connector.