40. Drive Sprocket Support Assemble

Tools Required:
- J 8092 Driver Handle
- J 28677 Sprocket Support-Needle Bearing Installer





1. Install the drive sprocket support assembly (109).
2. Install the four drive sprocket support bolts (114) into the case.
- Tighten the bolts to 25 Nm (18 ft. lbs.).





3. If the bearing for the drive sprocket support is removed, perform the following steps:
3.1. Assemble J 28677 and J 8092.
3.2. Use the assembled tools in order to install the drive sprocket support bearing assembly (108).