Seals and Gaskets: Service and Repair

Removal Procedure
1. Remove the drive axle.
2. Remove the intermediate shaft.
3. Remove the drive axle oil seal.
4. Fill between the oil seal lips with chassis grease GM P/N 1051344 or equivalent.

Installation Procedure
1. Install the Drive Axle Seal.
2. Install the intermediate shaft.
3. Install the drive axle.
4. Install the ball joint. Refer to Lower Ball Joint Replacement in Steering and Suspension.
5. Install the stabilizer shaft.
6. Install the tire and wheel assembly.
7. Remove the safety stand.
8. Lower the vehicle.
9. Check and Fill the Transaxle Fluid. Refer to Transmission Fluid Checking Procedure.