Intermediate Shaft Assemble
^ Tools Required- J 24433 Press Tube
1. Install the caged needle bearings (5).
2. Install the 2nd gear (4).
3. Install the 2nd gear inner cone (3).
4. Install the 2nd gear blocking ring (2).
5. Install the 2nd gear outer cone (1).
Important: Make sure to properly align the synchronizer to the gear and notches in the blocking ring.
6. Install the 1st/2nd synchronizer using J 24433 and a hydraulic press.
Important: Install the bearing collar oil hole 180' from shaft oil hole.
7. Install the thrust washer (2) and the bearing collar (1) using an appropriate tool and a hydraulic press.
8. Instal I the 1st gear outer cone (3).
9. Install the 1st gear blocking ring (2).
10. Install the 1st gear inner cone (1).
11. Install the roller bearing.
12. Install the 1st gear.
13. Install the roller bearing.
14. Install the thrust washer using J24433 and a hydraulic press.