Output Shaft Assemble

^ Tools Required
- J 24433 Press Tube

Important: Make sure the oil hole in the collar is 900 from the oil hole in the output shaft.





1. Install the thrust washer and collar using the J-24433 and a hydraulic press.
2. Install the caged needle bearings (3).
3. Install the reverse gear (2).
4. Install the reverse gear blocking ring (1).





5. Install the 5th/Reverse synchronizer using the J 24433 and a hydraulic press.





6. Install the bearing collar using an appropriate tool and a hydraulic press.





7. Install the 5th gear blocking ring (3).
8. Install the two caged needle bearings (2).
9. Install the 5th gear (1).





10. Install the 3rd gear using the J 24433 and a hydraulic press.





11. Install the 5th gear using the J 24433 and a hydraulic press.