Transmission Mount Replacement - Front

Inspection Procedure
1. Pull up and down on the transaxle case while observing the front lower transaxle mount.
2. Replace a mount when the following conditions occur:
3. The rubber separates from the metal case.

Notice: Refer to Fastener Notice in Service Precautions.

4. If movement occurs between the metal plate of the mount and its attaching point, tighten the mount bolts.
^ Tighten the bolts to 75 Nm (55 ft. lbs.).

Removal Procedure





1. Remove the washer solvent container.
2. Position the following items in order to support the transaxle:
^ A block of wood
^ A jack stand





3. Remove the transaxle mount thru-bolt.





4. Remove the transaxle to engine block bolts.
5. Remove the front transaxle mount.

Installation Procedure





1. Install the front transaxle mount.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the front transaxle mount bolts.
Tighten the bolts to 75 Nm (60 ft. lbs.).

3. Install the front transaxle mount thru bolt.
Tighten the bolt to 60 Nm (44 ft. lbs.).

4. Install the washer solvent container. Refer to Washer Solvent Container Replacement in Wipers/Washer Systems.
5. Install the left front splash shield.
6. Install the left front tire and the wheel assembly.
7. Lower the vehicle.
8. Remove the jack stand.