Transmission Mount Replacement - Rear

Inspection Procedure
1. Pull up and down on the transaxle case while observing the rear transaxle mount.
2. Replace a mount when the following conditions occur:
3. The rubber separates from the metal case

Notice: Refer to Fastener Notice in Service Precautions.

4. If movement occurs between the metal plate of the mount and its attaching point, tighten the mount bolts.
^ Tighten the bolts to 75 Nm (55 ft. lbs.).

Removal Procedure





1. Loosen but do not remove the rear transaxle mount bolts.
2. Raise and support the vehicle. Refer to Vehicle Lifting.





3. Use the following items in order to support the transaxle:
^ A wood block
^ A jack stand





4. Remove the rear transaxle mount thru-bolt.





5. Remove the rear transaxle mount bolts.
6. Remove the rear transaxle mount.

Installation Procedure
1. Position the rear transaxle.
2. Start the rear transaxle mount bolts.

Notice: Refer to Fastener Notice in Service Precautions.






3. Install the transaxle mount thru-bolt.
^ Tighten the bolt to 75 Nm (55 ft. lbs.).

4. Remove the following items from under the transaxle:
^ The wood block
^ The jack stand

5. Lower the vehicle.
6. Install the rear bolts.
^ Tighten the bolts to 75 Nm (55 ft. lbs.).