Wiper Motor Replacement
REMOVAL PROCEDURETOOLS REQUIRED
J 39232 Wiper Transmission Separator
1. Remove the wiper arms.
2. Remove the plenum chamber water deflector.
3. Remove the electrical connector from the wiper motor.
4. Remove the three screws and the wiper drive system module from the vehicle.
5. Remove the wiper transmission from the wiper motor crank arm using the J 39232.
6. Remove the two screws and the wiper motor from the tube frame.
INSTALLATION PROCEDURE
TOOLS REQUIRED
J 39529 Wiper Transmission Installer
NOTE: Refer to Fastener Notice in Service Precautions
1. Install the wiper motor onto the tube frame with the two screws.
Tighten
Tighten the screws to 10 N.m (88 lb in).
2. Install the wiper transmission onto the wiper motor crank arm using the J 39529.
3. Install the wiper drive system module onto the vehicle with the three screws.
Tighten
Tighten the screws to 10 N.m (88 lb in).
4. Connect the electrical connector onto the wiper motor.
5. Install the plenum chamber water deflector.
6. Install the wiper arms.
7. Operate the wipers and check for proper operation.